Desain Lampu Cerdas Berbasis Arduino Nano Untuk Kondisi Bencana
- Dwi Ajiatmo Universitas Darul Ulum, Jombang, Indonesia
-
Fahad Abdul Malik
*
Universitas Darul Ulum, Jombang,
Indonesia
- Agus Raikhani Universitas Darul Ulum, Jombang, Indonesia (*) Corresponding Author
Abstract
This research offers the manufacture of an emergency light prototype using Arduino Nano as the main controller. This prototype uses a buck converter in collaboration with an Arduino Nano to regulate the duty cycle with Pulse Width Modulation, based on feedback from voltage and current sensors. MOSFETs are used to regulate the voltage from a 10 Wp solar panel using the PWM method which is controlled by Arduino Nano. This buck converter is an inverting type because it changes the position of the supply voltage. Maximum Power Point Tracking (MPPT) technique is used to optimize energy from solar cells by finding optimal working points, ensuring maximum efficiency. This research also uses a 3.7 V lithium battery with a capacity of 18,650 mAh as a load for a series of prototype lights with the Joule Thief concept. The Joule Thief circuit is a minimalist oscillating voltage amplifier that is economical and easy to make, suitable for driving LED lights or DC dynamos. The results of this research show that the DC-DC MPPT buck converter based on the Arduino nano microcontroller can work well. By setting the duty cycle to 80 percent and a frequency of 62.5 kHz, current and voltage measurements produce an output of 4.95 volts - 5 volts.
Downloads
References
Akbar Ricky, Darman Ridho, Marizka, Namora Jesi, and Ardewati Novisa, “JEPIN (Jurnal Edukasi dan Penelitian Informatika),” J. Eduikasi dan Penelit. Inform., vol. 4, no. 1, pp. 30–35, 2018.
A. Gouder and B. V. Lotsch, “Integrated Solar Batteries: Design and Device Concepts,” ACS Energy Lett., vol. 8, no. 8, pp. 3343–3355, 2023, doi: 10.1021/acsenergylett.3c00671.
W. A. Jabbar, W. K. Saad, Y. Hashim, N. B. Zaharudin, and M. F. Bin Zainal Abidin, “Arduino-based Buck Boost Converter for PV Solar System,” 2018 IEEE 16th Student Conf. Res. Dev. SCOReD 2018, pp. 1–6, 2018, doi: 10.1109/SCORED.2018.8710807.
P. Srivastava, P. Gupta, and A. Singh, “Critical Factors Affecting Efficiency of Maximum Power Point Tracking in Solar Cells,” SAMRIDDHI A J. Phys. Sci. Eng. Technol., vol. 7, no. 01, pp. 01–08, 2015, doi: 10.18090/samriddhi.v7i1.3265.
D. Purwanto, “Rekayasa Energi Pada Lampu Darurat Di Ruang Tunggu ( Halte ) Menggunakan Teknologi Joule Thief,” pp. 1–15.
N. Jamala, “ANALISIS PENCAHAYAAN BANGUNAN HEMAT ENERGI (Studi Kasus : Gedung Wisma Kalla di Makassar),” AGORAJurnal Penelit. dan Karya Ilm. Arsit. Usakti, vol. 15, no. 2, pp. 62–70, 2015, doi: 10.25105/agora.v15i2.2028.
A. Mujadin and S. Rahmatia, “Joule Thief Sebagai Boost Converter Daya LED Menggunakan Sel Volta Berbasis Air Laut,” J. Al-AZHAR Indones. SERI SAINS DAN Teknol., vol. 4, no. 2, p. 52, 2018, doi: 10.36722/sst.v4i2.254.
O. Nabil, B. Bachir, and A. Allag, “Implementation of a new MPPT Technique for PV systems using a Boost Converter driven by Arduino MEGA,” Proc. - Int. Conf. Commun. Electr. Eng. ICCEE 2018, pp. 1–5, 2019, doi: 10.1109/CCEE.2018.8634503.
A. Al-Gizi, M. Al-Saadi, S. Al-Chlaihawi, A. Craciunescu, and M. A. Fadel, “Experimental installation of photovoltaic MPPT controller using arduino board,” 2018 Int. Conf. Appl. Theor. Electr. ICATE 2018 - Proc., pp. 1–6, 2018, doi: 10.1109/ICATE.2018.8551397.
Z. Q. Wu, C. Y. Liu, D. L. Zhao, and Y. Q. Wang, “Parameter identification of photovoltaic cell model based on improved elephant herding optimization algorithm,” Soft Comput., vol. 27, no. 9, pp. 5797–5811, 2023, doi: 10.1007/s00500-023-07819-4.
A. C. M. Shubham Mishra,Gaurav Dwivedi, Subho Upadhyay, “Modelling of standalone solar photovoltaic based electric bike charging,” in Materials Today: Proceedings, 2022, vol. 49, no. 8.5.2017, pp. 473–480. doi: https://doi.org/10.1016/j.matpr.2021.02.738.
I. Robandi, D. Ajiatmo, and Muhlasin, “Optimization PI-ACO for Photovoltaic System Battery and Supercapacitor on Electric Vehicle,” Proc. - 2021 Int. Semin. Intell. Technol. Its Appl. Intell. Syst. New Norm. Era, ISITIA 2021, pp. 370–375, 2021, doi: 10.1109/ISITIA52817.2021.9502221.
H. Nurohmah et al., “Komparasi PID , FLC , dan ANFIS sebagai Kontroller Dual Axis Tracking Photovoltaic berbasis Bat Algorithm,” pp. 71–77, 2022.
S. Gupta, “Hardware Implementation of Low Cost MPPT using Arduino for PV application,” IEEE, 2020.
Y.-C. L. Ting-Chung Yu, “a Study on Maximum Power Point Tracking Algorithms for Photovoltaic Systems,” International Journal of Advance Engineering and Research Development, vol. 2, no. 11. 2018. doi: 10.21090/ijaerd.021119.
J. Kumar, N. R. Parhyar, M. K. Panjwani, and D. Khan, “Design and performance analysis of PV grid-tied system with energy storage system,” Int. J. Electr. Comput. Eng., vol. 11, no. 2, pp. 1077–1085, 2021, doi: 10.11591/ijece.v11i2.pp1077-1085.
S. Paul Ayeng’o, T. Schirmer, K. P. Kairies, H. Axelsen, and D. Uwe Sauer, “Comparison of off-grid power supply systems using lead-acid and lithium-ion batteries,” Sol. Energy, vol. 162, no. December 2017, pp. 140–152, 2018, doi: 10.1016/j.solener.2017.12.049.
Y. Yongchang and Y. Chuanan, “Implementation of a MPPT Controller Based on AVR Mega16 for Photovoltaic Systems,” Energy Procedia, vol. 17, pp. 241–248, 2012, doi: 10.1016/j.egypro.2012.02.090.
D. Ajiatmo and I. Robandi, “Modeling and simulation performance of photovoltaic system integration battery and supercapacitor paralellization of MPPT prototipe for solar vehicle,” in ENGINEERING INTERNATIONAL CONFERENCE (EIC) 2016, 2017, vol. 1818, p. 020076. doi: 10.1063/1.4979943.
P. D. Rishabh Chopda, Alisha Gupta, Palak Kabra, “Joule Thief and its Applications,” Int. J. Res. Appl. Sci. Eng. Technol., vol. 9, no. December, pp. 1–23, 2021, doi: https://doi.org/10.22214/ijraset.2021.39190.
S. Vonsien and R. Madlener, “Li-ion battery storage in private households with PV systems: Analyzing the economic impacts of battery aging and pooling,” J. Energy Storage, vol. 29, no. June, p. 101407, 2020, doi: 10.1016/j.est.2020.101407.
S. Abdussamad, “Rancang Bangun Inverter Mini 1 . 5 V dc to 220 V ac Untuk Lampu Darurat,” J. Tek., vol. 18, no. 1, pp. 7–16, 2020.
Y. Prabowo, S. Broto, and G. Gata, “Kajian Efektifitas Sirkuit Joule Thief dan Aplikasi,” vol. 17, no. 1, pp. 39–45, 2020, [Online]. Available: https://journal.budiluhur.ac.id/index.php/bit
U. Yilmaz, “Improved MPPT method to increase accuracy and speed in photovoltaic systems under variable atmospheric conditions,” Int. J. Electr. Power Energy Syst., vol. 113, pp. 634–651, 2019, doi: 10.1016/j.ijepes.2019.05.074.
Bila bermanfaat silahkan share artikel ini
Berikan Komentar Anda terhadap artikel Desain Lampu Cerdas Berbasis Arduino Nano Untuk Kondisi Bencana
Pages: 42-49
Copyright (c) 2023 Dwi Ajiatmo, Fahad Abdul Malik, Agus Raikhani
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under Creative Commons Attribution 4.0 International License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (Refer to The Effect of Open Access).
